will be charged to 100 percent needs another 50 percent (.50)).
• Multiply the Amp Hour rating by the charge needed (.50) and divide by the charger setting (2 or 10 amps).
• Multiply the result by 1.25 and you’ll have the approximate time needed, in hours, to bring the battery to full charge.
•Add one additional hour for a
Example:
Amp Hour Rating x charge needed x | 1.25 | = | hours of |
Charger Setting |
|
| charge |
100 (AH Rating) x .50 (charge needed) x | 1.25 | = | 6.25 |
50 (Charger Setting) |
|
| hours |
100 x .50 = 1.25 x 1.25 = 1.5625
50
You will need to charge your
15.using the engine start feature
Your battery charger can be used to jump‑start your car if the battery is low. Follow these instructions when using the ENGINE START feature.
15.1Set the POWER switch to the OFF position. Then follow the instructions for connecting the charger to the battery and power source in the section “Charging a battery in the vehicle.”
15.2Set the BATTERY switch to 6V or 12V to match the battery’s voltage.
15.3Set the POWER switch to the ON position. The METER display will show
MAN (manual mode).
15.4Touch RESET, MANUAL and ENGINE START pads in that order. Wait for the display to show RDY. The charger is now ready to have the engine cranked.
15.5Crank the engine for no more than 5 seconds. If it does not start, wait 3 minutes. (The display will show WAIT during this time and RDY when the time is up.)
15.6During extremely cold weather, or if the battery is severely exhausted, charge the battery for about 5 minutes in 60 amp setting before cranking the engine.
15.7If the engine still does not start, charge the battery for five more minutes before cranking it again for five seconds.
15.8After the engine starts, unplug the charger power cord from the wall outlet.
Then move the POWER switch to the OFF position before disconnecting from the battery.
•16 •
