∫To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume is set low, for example, it is possible to reduce the dialog enhancing effect as follows:
Press and hold [TV] on the remote control and [s VOL] on the active subwoofer for more than 2 sec.
∫To turn off VIERA Link “HDAVI Control”
When “HDAVI Control” compatible equipment does not work well with this system, for example, it is possible to turn off this function as follows:
≥When VIERA Link is turned off the ARC function is not available. Be sure to connect the optical digital audio cable. (> 19)
1Press and hold [MUTE] on the remote control and
[s VOL] on the active subwoofer for more than 2 sec.
2After the setting has changed, turn off all the connected devices and then turn them on again.
∫To turn off the volume limitation
If a state of the lowered volume disturbs you every time this system turns on, for example, it is possible to turn off this function as follows:
Press and hold [MUTE] on the remote control and [VOL r] on the active subwoofer for more than 2 sec.
The settings of the
≥All the indicators will blink once when the setting is changed.
Troubleshooting
Before requesting for service, make the following checks. If you are in doubt about some of the check points, or if the solutions indicated in the following guide do not solve the problem, refer to “Customer Services Directory (United States and Puerto Rico)” on page 30 if you reside in the U.S.A. or Puerto Rico, or refer to “WARRANTY SERVICE” on page 31 if you reside in Canada.
To return to the factory preset.
While this system is on, press [Í/I] on the active subwoofer for more than 4 sec.
(All the indicators will blink twice when the active subwoofer is reset.)
If the system does not operate as expected, returning the settings to the factory preset may solve the problem.
≥The remote control code will return to “1” when this system is returned to the factory preset. To change the remote control code, refer to page 25.
General operation
No power.
≥Insert the AC power supply cord securely. (> 20)
≥After turning this system on, if the indicators blink and this system immediately turns off, unplug the AC power supply cord and consult your dealer.
The remote control does not work properly.
≥The battery is depleted. Replace it with a new one. (> 7)
≥It is possible that the insulation sheet has not been removed. Remove the insulation sheet. (> 7)
≥It may be necessary to set the code of the remote control again after changing the battery in the remote control. (> 25)
≥Use the remote control within the correct operation range. (> 9)
The “TV” indicator blinks, but there is no sound.
Remove the AC power supply cord and consult your dealer. If there are any other indicators blinking, be sure to inform the blinking indicators to your dealer.
This system is automatically switched to standby mode.
This system will automatically switch to standby mode when no signal is input and no operation is performed for approx. 30 minutes. (> 20)
26
VQT4D53
