Place the speakers vertically
∏ | 1 | Speaker (L) | ∏ | 1 | Speaker (R) | ∏ 2 Speaker cables |
|
|
|
|
|
| (L): WHITE |
|
|
|
|
|
| (R): RED |
∏ | 4 | Screws | ∏ | 2 | Front |
|
|
|
|
|
| ornaments |
|
≥For a safety measure to prevent the speakers from falling, refer to page 16.
≥To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
Attach the front ornaments.
≥Keep the screws out of reach of children to prevent swallowing.
≥Be sure to insert the screws following the order as indicated in the illustration.
Front view
Rear view
2 1
Connect the speaker cables.
≥Insert the wire fully, taking care not to insert beyond the wire insulation.
≥To make sure that the speaker cable is connected to the correct speaker, match the color of the speaker connector with the color of the L/R indicator on the speaker label so as not to connect the speaker cable to the wrong speaker.
Push
1 Insert the wire fully. r: White
s: Blue line
2 Press into the groove.
Drive a screw (not supplied) into the wall.
≥Use the measurements indicated below to identify the screwing positions on the wall.
≥Leave at least 20 mm (25/32q) of space above and on each side of the speaker to allow enough space for fitting the speaker.
≥The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 kg (72.8 lbs).
≥Keep the screws out of reach of children to prevent swallowing.
12
VQT4D53