Sears 315.27516 owner manual General, Lubrication, Extension Cords

_1 WARNING: When servicing, use only identical Craftsman replacement parts. Use of any other

part may create a hazard or cause product damage.

GENERAL

Only the parts shown on parts list, page 19, are intended to be repaired or replaced by the customer. All other parts represent an important part of the double insulation system and should be serviced only by a qualified Sears service technician.

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.

_k WARNING: Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc. come in contact with plastic parts. They contain chem_als that can damage, weaken or destroy plastic.

It has been found that electric tools are subject to accelerated wear and possible premature failure when they are used on fiberglass boats, sports cars, wallboard, spackling compounds, or plaster. The chips and grindings from these materials are highly abrasive to electric tool parts such as bearings, brushes, commutators, etc. Consequently, it is not recommended that this tool be used for extended work on any fiberglass material, wallboard, spackling compounds, or plaster. During any use on these materials it is extremely important that the tool is cleaned frequently by blowing with an air jet.

,_ WARNING: Always wear safety goggles or safety glasses with side shields during power tool

operation or when blowing dust. If operation is dusty, also wear a dust mask.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrication is required.

EXTENSION	CORDS	_,	CAUTION: Keep extension cords away from the
			cutting area and position the cord so that it will
The use of any extension cord will cause some loss of
			not get caught on lumber, tools, etc., during
power. To keep the loss to a minimum and to prevent
			cutting operation.
tool overheating, use an extension cord that is heavy
enough to carry the current the tool will draw.
A wire gage size (A.W.G.) of at least 12 is			WARNING: Check extension cords before each
recommended for an extension cord 50 feet or less in
			use. If damaged replace immediately. Never use
length. When working outdoors, use an extension
			tool with a damaged cord since touching the
cord that is suitable for outdoor use. The cord'sjacket
			damaged area could cause electrical shock
will be marked	WA.
			resulting in serious injury.

Extension cords suitable for use with your circular saw are available at your nearest Sears Retail Store.

16