Sears 316.2926 NOTE:, Handle Set-Up, Loose Parts In Carton, ASSEMBLING CULTIVATOR, Removing Unit From Carton, Tools Needed for Assembly

ASSEMBLY INSTRUCTIONS

NOTE: Reference to right or left hand side of the cultivator is observed from the operating position.

Removing Unit From Carton

1.Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.

2. Remove all loose parts that may be included with unit.

3.Cut along corners, lay carton down flat, remove and set safely aside any packing material and/or loose

cardboard.

4. Roll or slide unit out of carton and check carton thoroughly for loose parts.

Loose Parts In Carton

• Operator’s Manual

Tools Needed for Assembly

• None

WARNING: personal injury, do
To prevent serious
not connect electric
extension cord to unit until fully completing	Fig. 1
cultivator assembly	Fig. 1

ASSEMBLING CULTIVATORHandle Set-Up

1.Loosen each hand knob found on the inside of the upper handle (Fig. 1).

2.Gently lift and pivot the upper handle into the operating position (Fig. 2).

3. Secure the upper handle and lower handle by tightening the hand knobs (Fig. 2). Each carriage

bolt must be seated properly into the square hole	2
found in the plastic connector.	2	1
		1

Fig. 2