ASSEMBLY INSTRUCTIONS

Using the Cord Retainer

 

An extension cord retainer is suspended on the cord

 

guide bar found on the upper handle.

 

NOTE: Do not plug your extension cord into the power

 

source receptable (outlet) prior to routing it

 

through the cord retainer and connecting the

 

extension cord to the cultivator's cord outlet

 

receptacle.

 

To properly route your extension cord through the cord

 

retainer:

 

1. Approximately eight inches from its end, crease your

 

extension cord to form a tight loop.

 

2. Push the loop through the bottom hole in the cord

 

retainer (Fig. 3).

 

3. Position the loop over the clip found on the cord

 

retainer and pull down until the cord fits snugly into

 

the clip (Fig. 4).

 

NOTE: Use a UL-approved extension cord. A 100-foot,

 

14-gauge cord is recommended. A 50-foot, 16-

 

gauge cord is acceptable. Refer to the small chart

 

found on Page 3.

Fig. 3

The cord retainer and the guide bar work together to

 

secure your extension cord and safely limit its movement.

 

The cord retainer (with the extension cord) will slide along

 

the guide bar as the cultivator is moved to the left or to

 

the right (Fig. 5).

 

Fig. 4

Fig. 5

9