7.Place the drawbar tongue onto the axle and latch stand bracket then slide the axle through the wheel support and drawbar tongue. See figure 4.
AXLE |
DRAW BAR |
TONGUE |
LATCH STAND |
BRACKET |
FIGURE 4
8.Assemble a spacer tube, a 1" flat washer, a wheel (valve stem facing out) and another 1" flat washer onto the axle as shown in figure 5. Insert a cotter pin through the axle, spreading the ends. Fill wheel hub with grease. Repeat on other end of axle.
IMPORTANT: Pump grease into grease fittings until it is forced out through ends of wheel hub.
WHEEL | SPACER | AXLE |
| ||
| TUBE |
|
FLAT |
|
|
WASHER |
|
|
| FLAT | |
| WASHER | |
COTTER PIN |
|
|
FIGURE 5
9.Assemble the latch stand plate and the latch stand bracket to the bottom of the poly tray using four 1/4" x 3/4" hex bolts, 1/4" flat washers and 1/4" nylock nuts. The aligning tab on the bottom of the latch stand bracket must be towards the rear of the cart. Tighten. See figure 6.
| 1/4" x 3/4" | |
| HEX BOLT | |
| 1/4" FLAT | |
| WASHER | |
LATCH | TAB | |
STAND PLATE | ||
| ||
LATCH STAND |
| |
BRACKET | 1/4" NYLOCK NUT | |
|
FIGURE 6
10.Place the poly tray down onto the wheel support, positioning it so that the latch stand bracket snaps under the latch lock lever. Fasten the tray to the wheel support using eight 5/16" x 3/4" truss head bolts and 5/16" nylock nuts as shown in figure 7. Tighten.
5/16" x 3/4" |
TRUSS HEAD |
BOLT |
5/16" NYLOCK |
NUT |
LATCH LOCK |
LEVER |
FIGURE 7
5
