Sears 485E user manual

3.Attach a Pedal (31) to one of the Pedal Arms (12) with three #8 x 3/4Ó Round Head Screws (16) as shown.

Repeat this step to attach a Pedal to the other Pedal Arm (not shown).

4.Make sure that there are Pedal Arm Bushings (42) in the ends of both Pedal Arms (12).

Identify the Left Handlebar (8) (there is a decal on the Left Handlebar for identification). Slide a Handlebar Spacer (39) and one of the Pedal Arms (12) onto the Left Handlebar as shown (these parts fit tightly; it may be helpful to use the rubber mallet). Refer to the PART IDENTIFICATION CHART on page 5 and iden- tify the 3/4Ó Axle Caps (43). Tap a 3/4Ó Axle Cap onto the Left Handlebar.

Repeat this step to attach the other Pedal Arm (12) to the Right Handlebar (9).

5.Slide a Pedal Arm Spacer (41) and the left Pedal Arm (12) onto the axle on the left Pulley Arm (34) (these parts fit tightly; it may be helpful to use the rubber mallet). Be careful not to confuse the left Pedal

Arm with the right Pedal Arm (not shown); look at the position of the Left Handlebar (8) to identify the left Pedal Arm.

Tap a 3/4Ó Axle Cap (43) onto the axle on the left Pulley Arm (34).

Repeat this step to attach the right Pedal Arm (not shown).

7

3
	31
	12
	16
4
	9
	8
	12
	39
42
43
12
5
8	34
	41
	12
	43