STEP 2: (SEE FIGURE 2 AND 1)

•Slide the axle through the two axle brackets.

•Assemble a spacer (R), a 3/4" washer (H), a wheel (valve stem facing out) and another 3/4" washer (H) onto the axle. Assemble a cotter pin (M) through the end of the axle. Repeat on other end.

•Tighten the four nuts which fasten the axle clamps to the frame tubes. Refer back to fi gure 1.

1/8" x 1-1/2"

COTTER PIN (M)

SPACER (R)

3/4" WASHER (H)

FIGURE 2

STEP 3: (SEE FIGURE 3)

•Assemble a hitch arm to the inside of a frame tube underneath the tank. Use two 5/16" x 2" hex bolts (A) and 5/16" nylock nuts (F). Do not tighten yet. Repeat for other side.

5/16" NYLOCK NUT (F)

5/16" x 2"

HEX BOLT (A)

HITCH ARM

FIGURE 3

STEP 4: (SEE FIGURE 4)

•Fasten the ends of the hitch arms together using two 5/16" x 1-1/4" hex bolts (B) and 5/16" nylock nuts (F).

Do not tighten yet.

•Assemble the hitch brackets to the hitch arms using two 5/16" x 2" hex bolts (A) and 5/16" nylock nuts

(F). Position each bolt behind a cross bolt in the hitch arms Do not tighten yet.

•Tighten all nuts assembled in steps 3 and 4 at this time

5/16" x 2" HEX BOLT (A)

5/16" NYLOCK NUT (F)

5/16" x 1-1/4" HEX BOLT (B)

5/16" NYLOCK NUT (F)

FIGURE 4

STEP 5: (SEE FIGURE 5)

•Assemble the boom mount bracket to the rear of the frame tubes using two 5/16" x 2" hex bolts (A) and 5/16" nylock nuts (F).

5/16" NYLOCK NUT (F)

5/16" x 2" HEX BOLT (A)

FIGURE 5

REAR VIEW

5