STEP 6: (SEE FIGURE 6)

•Assemble the boom bars to the boom mount bracket using two 5/16" x 1-1/4" carriage bolts (C), tooth lock washers (J) (between the bar and bracket), 5/16" fl at washers (G) and knobs (N). The boom connecting hose should extend upward.

NOTE: Make sure the nozzles are adjusted so that the openings face straight down when the boom bar is in the horizontal operating position.

BOOM CONNECTING HOSE

5/16" FLAT

WASHER (G)

KNOB (N)

WASHER (J)

 

(TOOTH LOCK)

BOOM BAR

CARRIAGE BOLT 5/16" x 1-1/4" (C)

FIGURE 6

STEP 7: (SEE FIGURE 7)

•Assemble the large (P) and small (O) spray gun clips to the side of the tank using two #10 x 1/2" screws (D) and #10 lock washers (I).

STEP 8: (SEE FIGURE 8)

•Insert a garden hose gasket (T) into the swivel nut on the bypass/return hose. Screw the nut onto the upper outlet of the "Y" valve fi tting. Place the other end of the hose down through the hole at the rear of the tank.

•Insert a garden hose gasket (T) into the swivel nut on the boom connecting hose. Screw the nut onto the lower outlet of the "Y" valve fi tting.

•Slide the coiled hose clamp (S) onto the spray gun hose. Push the hose onto the hose adapter on the side of the "T" fi tting as shown in fi gure 8. Tighten the clamp around the hose and the adapter. Snap the spray gun into the clips on the side of the tank.

•Carefully screw the pressure gauge (Q) into the top of the "T" fi tting.

BYPASS/RETURN HOSE

SPRAY

GUN COILED

HOSE HOSE

CLAMP (S)

GARDEN

HOSE

GASKET (T)

PRESSURE

GAUGE (Q)

BOOM CONNECTING HOSE

FIGURE 8

 

SPRAY

GUN

 

#10 x 3/8"

CLIP (P)

(LARGE)

SPRAY GUN

SCREW (D)

 

 

CLIP (O) (SMALL)

#10 LOCK

 

 

 

WASHER (I)

 

 

 

FIGURE 7

6