25.Assemble a short tarp strap to rear door using one
1/4" x
1/4" nylock nut. Assemble an "S" hook through loose end of strap. See figure 15. Repeat on other side of door.
26.Assemble door to rear of cart by resting bottom of door on door supports and pushing top of door in against cross brace. Secure top of door using door latches on each side. See figure 15.
27.Hook both the tarp straps onto the 1/4" x 1" hex bolts in the sides of the cart. See figure 15.
DOOR LATCH |
|
| 1/4" x |
| 1/4" FLAT WASHER |
| TARP STRAP (SHORT) |
1/4" FLAT | "S" HOOK |
| |
WASHER |
|
| DOOR |
1/4" NYLOCK NUT | SUPPORTS |
| 1/4" x 1" |
| HEX BOLT |
FIGURE 15
28.Attach the engine/impeller housing assembly to the upper holes in the angles welded to the tongue. Use four 5/16" x 3/4" hex bolts and 5/16" nylock nuts.
Tighten. See figure 16.
| 5/16" |
| NYLOCK |
| NUT |
| 5/16" x 3/4" |
| HEX BOLT |
WELDED | FRONT |
ANGLES | TONGUE |
FIGURE 16
29.Remove the hex bolts and nylock nuts from the two holes in the impeller housing shown in figure 17.
Assemble the hose hanger bracket to the impeller housing using the bolts and nylock nuts which you removed.
USE 
THESE
HOLES
HOSE HANGER 
BRACKET
USE PRE-
ASSEMBLED
BOLTS AND
NYLOCK NUTS
FIGURE 17
30.Assemble the elbow to the impeller housing using four 5/16" x 3/4" self tapping hex bolts and four nylon washers. Push while turning to help start the bolts into the unthreaded holes. Tighten. See figure 18.
31.To center the elbow with the opening in the hard top:
a.Push the vinyl boot back inside the opening.
b.Loosen by approximately 1/4 turn each, the four bolts that you assembled in figure 16.
c.Push against the elbow to center it with the sides
of the opening.
d. Retighten the four bolts that you loosened.
32. Pull the vinyl boot onto the end of the elbow.
Center elbow between |
sides of opening |
NYLON |
WASHER |
5/16" x 3/4" |
HEX BOLT |
(Thread Forming) |
Loosen (4) bolts |
1/4 turn each |
FIGURE 18
11
