Sears 536.79751 owner manual Bly, To Assemble the Edger, To Remove Edger from Carton

ASSE

,,= i i=1 q ,u i,=,11=1 i iiii, ii ,

GLASSES OR EYE SHIELDS WHILE

CAUTION: ALWAYS WEAR SAFETY

ASSEMBLING EDGER.

Figure 1 shows the edger completely assembled,

Reference to the right and left hand side of the edger is from the operator's position behind the unit

TO REMOVE EDGER FROM CARTON

_' Open the top of the carton

•Remove the packing material from the cation

=Remove the plastic parts bag from the carton

• Remove the control rod from the carton.

•Remove the handles from the carton.

e Cut down all four corners of the carton

TO ASSEMBLE THE EDGER

=Attach each rear wheel, with the ribs to the outside, to the edger (See Fig 2) with a 3/8-16 x 1,390 inch shoulder bolt, spacer and 3/8-16 hex wide flange lock nut (found in parts bag)

UPPER

HANDLE

CLUTCH LEVER

LOWER

HANDLE

STARTER

HANDLE

BLADE

GUARD

BLADE

BLY

qlll, l,ii,i i iii i , lil, i

Attach the front wheel, with the ribs to the outside,

to the edger (See Fig 2) with a 3/8-16 x 1 390 inch shoulder bolt and 3/8-16 hex wide flange lock nut

(found in parts bag),,

	WHEEL
3tS-16X1o390]NCH
SHOULDER BOLT	318.16 HEX NUT

SPACER

(NOT USED ON FRONT WHEEL)

VIEW FROM RIGHT SIDE OF UNIT

FIG. 2

Place the lower handle inside the edger frame (See Fig. 3A) and secure in place with four (4) 5/16-" hex head wide flange screws and four (4) 5/_ hex head bcknuts (found in parts bag).

5t16-18	HEX		LOW ER
HEAD	WIDE		/HANDLE
FLANGE		_	5t16-18 HEX

SCREWS

i

FRAME

FIG. 3A

FIG_ 1