i1,,,,i | i | i | iiii, |
,.SERVICE AND
TO REPLACE BELTS
The drive belts on this snow thrower are o! special construction and should be replaced with original equipment belts available from your nearest SEARS Store or Service Center_
You will need the assistanceof a second person while replacing the belts°
Drain the gasoline from the fueltankby removing the fuel line., Drain the gas and reinstall fuel line,,
AUGER DRIVE BELT
If your snow throwerwilt not discharge snow, and the auger drive belt isdamaged, replace it as to!lows:
®Disconnect the sparkplugwire.
o Remove the beltcover (See Fig,,26).
®Loosenthe belt guides (See Fig°27) and pullaway from the drivepulley.
eLoosen the auger idler pulley(See Fig. 28) and slip the belt out.,
eRemove top two bolls that secure auger housing to motor mount frame. Loosen bottom two bolts.,
Auger housing andmotormountIrame willseparate hinged by bottom two bolts.
eRemove brake arm from housing, Do not remove spdng,
eRemove the belt fromthe augerdrive engine pulley
eInstall the original equipmentreplacement bell in reverse order of removal,
eReinstall brake arm intohousing,,Insure brake arm
isfullyinsertedinto housingand brake pad is riding in pulley groove°
0Position drive belt onto the auger drive putley,
0Adjust thedr_vebelt (seeTo AdjustAuger Drive Belt paragraph on page 18),,
0Adjust the belt guides (see To Adjust The Belt Guides paragraphon page 20)+
0Reinstallthe beltcover.
OCheck clutch control cable adjustment (see page 18)+
•Reconnect the spark plug wire,,
GUIDE
(Lalt Hand)
AUGER
DRIVE
(Right Hand)
BELT
:R DRIVE
TRACTION DRIVE | PULLEY |
| |
IDLER PULLEY |
|
| PULLEY |
FIG, 27
!11'll_j II I
_32 | BELT | GUIDE |
|
| Hand) |
{Righ! Hand) | 3/32 | INCH |
AUGER |
|
|
PULLEY ENGAGED |
|
|
|
| IMPELLER |
|
| PUL L_Y |
,,i,, iii | ,lira i,,,,11, |
|
| FIG. 28 |
|
19
