8. tftapeholdsbottomdrawercovertodrawer
supports, remove the tape Pull drawer partway out Reach in, push the rear of the glass up and, at the same time, back, until it clears front_corner retainers
9.Tilt and remove the cover
10.Tilt and remove the drawer
After cleaning, replace drawers and covers in reverse order Reinstall the gasket at the rear of the top drawer Fitthe end of the plastic
drawer support into the stot on the gasket, with the rubber gasket flap facing you, Make sure the gasket snaps into place,
Then replace the light panel by hanging top of panel on
upper pins and pushing in at bottom
Behind Refrigerator
Take care moving your refrigerator away from the wa_] All b/pes of floor coverings can be damaged, particularly cushioned coverings and those with embossed surfaces Pull _herefrigerator straight out and return it to position by pushing it straight in Moving refrigerator in a sicledirection may damage floor covering or refrigerator
Light Bulb Replacement
Unplug the refrigerator before changing a light bulb.
Fresh Food
1.Pull off temperature control knobs
Pin
Drain Opening in Freezer Compartment
When cleaning, remove the freezer bin and flush
a solution of baking soda (one teaspoon) and two cups of hot (not boiling) water through the drain
line with the help of a meat baster This will
help eliminate odor and
reduce the likelihood of a clogged drain tine
tf drain becomes clogged, use a meat baster and
Condenser
The condenser is located behind the base grille, For most efficient operation, remove the Base grille and sweep away or vacuum up dust that is readily accessible For best resu]ts, use a brush specially
designed for this purpose, it is available at your Sears store or service center This easy cleaning operation should be done at least once a year
2, Pul! the bottom of the light shield down and forward, then rotate the top up and off
After replacing with same size bulb, reinstall light shield
Fresh Food Compartment--Lower Light (on some models)
This light is located behind a shield at the rear of the fresh food compartment,
1.Grasp the top edge of the shield and lift it up and forward to free its top edge
2_ After replacing with same size bulb, hook the top of the shield back in place
Freezer | Compartment |
|
|
1, Remove sheff iust below | L___ | Jt | |
light panel (Shelf will be |
|
| |
easier to remove if it is |
|
| |
emptied | first) |
|
|
2o Pull plastic light pane!
toward you° (It will bend to free tabs from grooves )
3.After replacing with same size bulb, reinstall panel and sheif_
13