![](/images/new-backgrounds/1010325/1032515x1.webp)
iNSTALLATiON
FINAL ASSEMBLY AND ADJUSTMENT
PUT FLOAT VALVE IN COOLER
Put the float valve through the spout hole and cabinet hole Tighten the ring nut Be sure the float moves straight up and down. TURN THE FLOAT UNTIL A NARROW SIDE IS UP. Snap the Sp(ash Guard Cover into the Water Spout as shown The Water Spout and Splash Guard Cover are provided
to prevent water from "spurting "and splashing out- side the Water Reservoir,
CONNECT WATER LiNE
For outdoor Hook Up, use #62527 Copper Hook Up Kit or #62528 Plastic Hook Up Kit Both kits contain all necessary fittings to connect water to cooler For indoor kit use copper tubing and #62522 self pierc- ing saddle valve.
PUT IN OVERFLOW PIPE (Fig. 11)
1 Push the drain fitting through the washer and water tray hole Tighten the ring nut. Screw the overflow pipe into the drain fitting Repeat for the second tray.
NOTE: INSTALL DRAIN FITTING INVERTED tF COOLER IS MOUNTED ON A PAD. CUT OFF THE OVERFLOW PIPETOP FLUSH WITH THE HEXAGONAL RING.
Put in the float valve side tray first The cros- sover tube and grommet MUST be on the float valve side (Fig 12).
Push the crossover tube into the grommet° Use
soap or detergent as a lubricant DO NOT USE
OIL,,
4 Put the second water tray in place. Push the crossover tube into the grommeL
ADJUST WATER LEVEL
5_ Turn on the water. Check the water level when the valve shuts off, If the water'level is above the tray water leve) mark bend the float rod down If the level is too low, bend the rod up,,
GROMMETS AND ALL CONNECTIONS
I NOTE: CHECK THE CROSSOVER PIPE FOR LEAKS.
PUT LOUVERS ON COOLER
Seepage 11
COMPRESSION
NUT
FLOAT
VALVE
NUT
P R EpSuS!ON _ | FERRULE |
% |
|
ADAPTER |
|
OVERFLOW
PIPE
DRAIN FITTING
WASHER
WATER LEVEL
MARK
GROMMET
CROSSOVER
PiPE FLOAT
VALVE
8