![](/images/new-backgrounds/1010325/103259x1.webp)
aNSTALLATnON
YOU MAY WANT TO CONVERT YOUR COOLER TO SIDE DISCHARGE (Figure 3)
|
|
| H.n |
CONVERTING | COOLER TO SiDE AIR | SIDE OUTLET | ,_ |
DISCHARGE | (FG.4) |
| DOWN OUTLET |
ORemove both louvers and set them where they will not fall See pg_ 11, "Taking Off Louver"
Q Remove four grille clips on side opposite motor
(_ Remove a reservoir by pushing the water cros- sover tube from the grommet and lifting out the
reservoir,,(_ (_) Remove the second reservoir as above.
Q Remove the screw that holds the wiring box, O Remove 1,_inch diameter and _ inch diameter
knockouts,,
O Remove two plastic plugs..
®Loosen screw holding pad motor receptacle bracket, slide bracket up and detach from cabinet flange,. Repeat on other side,.
9 Turn cooler to side outlet position (Figure 5)
REASSEMBLY AS SIDE
OUTLET COOLER (Fig 5)
(_) Move wiring box to new location,,
O Secure wiring box with screw removed at disassembly,
(_) Install four louver clips removed at disassembly,,
(_) Install two receptacle brackets removed at disassembly°
(_ Install two plastic plugs removed at
disassembly®
6.Assembly reservoirs, crossover tube and louv- ers after the cooler is installed in location, Use
soap or detergent to lubricate crossover tube
before inserting into grommet, DO NOT USE OIL.
ROUTE WIRES INSIDE OF PANEL | ® |