Sears 74182 Replacement Parts, Change coin sizing block, Replace coin receiver block into sfide

Models: 74182 64182

1 16
Download 16 pages 21.65 Kb
Page 12
Image 12

To remove block-out keys, pull straight up.

NOTE: Be sure block-out keys and/or dime inserts are seated properly and ratchet dog is in place with its spring connected (see FIGURE8).

Be sure the proper coin sizing block is in place.

Ratchet

Dog and

Block-Out

Keys

FIGURE 8

Change coin sizing block:

Remove two screws that hold upper coin chute cover. Remove cover (see FIGURE9).

Anti-Cheat

(2)Upper Coin Chute Cover

Ga te

STEP7

Replace coin receiver block into sfide:

Hold coin receiver right side up in the palm of one hand.

Lower coin slide until coin receiver block fits into the coin slide cavity. CAUTION: Do not dislodge ratchet dog and spring.

Hold coin receiver block in place with your fingers and turn slide upside down.

Insert and tighten screw.

STEP8

Install slide into coin chute. Slide can only be pushed in if the anti-cheat gate in flange is pushed to the left. (see FIGURE9).

STEP9

Replace coin slide stop with two screws. Replace coin slide return spring. Replacecoin slide extension with two screws (be sure spacers are in place).

STEP 10

Replacecoin slide mechanism in meter case. Replaceand tighten coin slide mounting bolt.

NOTE: It may be easier to insert coin slide mounting bolt if you remove the timer from the mounting screws temporarily.

Block Screws

(2) Coin Sizing_

 

 

Coin Sizing

FIGURE 10

;

Block

Remove two screws that hold coin sizing block to upper coin chute cover cover (see FIGURE10).

Put new coin sizing block in place. Reinsert and tighten mounting screws.

Replace coin chute cover. Reinsert and tighten screws.

REPLACEMENT PARTS

If replacement parts areneeded for your dryer, contact the source where you purchased your dryer, or call Sears Partsand Service Toll FreeNumber 1-800-4-MY-HOME (1-800-469-4663). Forcoin box parts, call 1-800-221-0982, Greenwald Industries.

Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

Destroy the carton and plastic bags after the dryer is unpacked. Children might use them for play. Cartons covered with rugs, bedspreads, or plastic sheets can become airtight chambers causing suffocation. Place all materials in a garbage container or make materials inaccessible to children.

The instructions in this manual and all other

literature included with this dryer are not meant to cover every possible condition and situation that may occur. Good safe practice and caution MUSTbe applied when installing, operating and maintaining any appliance.

12

Page 12
Image 12
Sears 74182, 64182 manual Replacement Parts, Change coin sizing block, Replace coin receiver block into sfide