Sears 74781 manual Safety Door Switch, E1 Lint Screen, Ik Model No. Plate, Performance Guide Label

FEATURES

E1 Lint Screen

Keep the lint screen clean. A lint-clogged screen will slow down the flow of air. This makes drying time longer and wastes energy. Clean the lint screen before each load as follows:

1.With dryer off, remove the screen by pulling straight up.

2.Roll the dry lint off the screen. Do not wet the screen or lint; wet lint is hard to remove.

3.Replace the cleaned lint screen.

Ik_ Model No. Plate

Shows model and serial numbers. Have these ready if you ever call for service.

l_ Performance Guide Label

Located inside the dryer door. Gives information on what to do if dryer

does not perform normally.

Fire Hazard.

Do not use your dryer while the lint screen is removed.

It could cause overheating and possible damage to fabrics and dryer parts or create a fire hazard. Lint screen must be pushed firmly into

place.

III I I I

NOTE: A whistle tone will remind you when the lint screen needs cleaning.

NOTE: If lint screen gets clogged by detergent or fabric softener build-up, remove and clean it with a nylon brush, hot water and liquid detergent. Dry and replace screen.

i_ Safety Door Switch

For safety, the switch shuts off dryei when door is opened. Dryer will not start until door is closed and START is pushed. Be sure the Cycle Selector Control is on a dry setting.

•El Easy Loader Door

Drop down door is located to reduce stooping. It can also serve as a shelf for folding clothes. The large opening makes it easy to load and unload and to see inside dryer. Clothes in dryer are easy to reach.

NOTE: If dryer drum is stained, clean it with a damp cloth and mild detergent.

For more detailed drying times, roles for safe operation, fabric care, maintenance and installation information, refer to the LAUNDRY

GUIDE and INSTALLATION INSTRUCTIONS you received with

yourdryer.

ii

Part No. 3392334 Printed in U.S.A.