Sears 831.154020 user manual

31.Attach the end of the Press Cable (109) to a “U”- bracket (50) with an M8 Washer (98) and an M8 Nylon Locknut (91). Note: Do not completely tighten the Locknut; it should be tightened so that only two threads of the Cable show past the Locknut, as shown in the inset drawing.

32.Locate the Butterfly Cable (106). Grease an M8 x 22mm Shoulder Bolt (39). Attach the Cable to the Left Butterfly Arm (6) with the Bolt and an M8 Nylon Locknut (91). Make sure the flat edge of the Cable is against the Butterfly Arm.

33.Wrap the Butterfly Cable (106) over a “V”-pulley (62). Attach the “V”-pulley, a Large Cable Trap (111), an M10 Washer (99), and two Full Finger Guards (104) to the Right Upright (2) with an M10

x62mm Bolt (73) and an M10 Nylon Locknut (90).

34.Wrap the Butterfly Cable (106) under a 90mm Pulley (63). Attach the Pulley and two Half Finger Guards (66) to the Double “U”-bracket (61) with an M10 x 48mm Bolt (84) and an M10 Nylon Locknut (90). Make sure the Finger Guards are oriented as shown.

35.Wrap the Butterfly Cable (106) over a “V”-pulley (62). Attach the “V”-pulley, a Large Cable Trap (111), an M10 Washer (99), and two Full Finger Guards (104) to the Right Upright (2) with an M10

x62mm Bolt (73) and an M10 Nylon Locknut (90).

31
109
			109
	98
				91
50	91
32
		39 Grease
			106
			6
Flat			91
Edge
33	2
	90	106
		111
			62
				73
	104	99		104
34		106
		63	90
	66		66
		61
	84
35	73
104
	62
99		106
	111
			2
	104
	90

15