HOW TO ADJUST THE DRIVE BELT
Ifyou can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need tobe adjusted.
Toadjust the drive belt, you must remove the shield
cover and the left shield (see the instructions below).
See EXPLODED DRAWING B on page 27. Using a
flat screwdriver, release thetabs along the sides ofthe
Shield Cover (37), and then remove the Shield Cover.
Next, remove the M4 x 16mm Screws (92) and the M4
x 12mm Self-tapping Screws (97) from the Left and
Right Shields (44, 45). Make sure to note which size
of Screw you remove from each hole. Then, gently
remove the LeftShield.
Loosen the Pivot Screw (88). Then, tighten the Drive
Belt Adjustment Screw (72) until the Drive Belt (46) is
tight.
When the Drive Belt (46) is tight, tighten the Pivot
Screw (88).
Then, reattach the left shield and the shield cover.
21