Sears 831.24843.0 Assembly, Make sure that the power cord is unplugged, Age the Upright Wire

ASSEMBLY

•Assembly requires two persons.

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish assembly.

•The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

•To identify small parts, see page 6.

•Assembly requires the following tools:

the included hex keys one Phillips screwdriver scissors

•To avoid damaging parts, do not use power tools.

1. Make sure that the power cord is unplugged.	1
Remove and discard the two screws (A) and the
shipping bracket (B) from the right side of the
Base (74). Then, remove and discard the screws
and shipping bracket (not shown) from the left	B
side of the Base.
	A
	74
2. Locate the Upright Wire (63) bundled between	2
the Base (74) and the Belly Pan (52). Route the
Upright Wire into the Base and out of the indi-
cated hole.
Press a Base Cap (70) into each side of the
Base (74).

See the inset drawing. Cut the plastic tie near
the Upright Wire (63). Be careful not to dam-
age the Upright Wire.	52	74

			Tie
63	Hole	70	Cut
			63

7