SERVICE AN ADJUSTMENTS

CLUTCH

ELECTRIC ._LOCATOR

CLUTCH

PULLEY

E

CLUTCHING

IDLER

STATIONARY "

IDLER

ELECTRmCCLUTCH

WiRiNGHARNESS

CONNECTOR

FiG, 27

TO ADJUST MOTION CONTROL LEVER

(See Fig. 28)

"NEUTRAL" position of the motion control lever has been preset at the factory and adjustment should not be nec- essary,

tf your unit tends to 'icreep"when the motion controt lever is in "NEUTRAL" position, adjust the neutral lever position as follows:

FORWARD ADJUSTMENT-

"Drive unit forward on a level surface.

Move motion control lever to the left and back until it stops against forward adjustment plate and release lever.

if unit "creeps" forward or backward, turn engine off and set parking brake.

From underside of fender, loosen the two (2) bolts securing forward adjustment plate and move plate 1/16" opposite the direction the unit "creeps":

Forward "creep", move plate backwards 1/16 inch, Reverse "creep", move plate forward 1/16 inch.

°Retighten bolts securely.

oRepeat forward drive test and, if necessary, readjust until "creep '_is eliminated.

REVERSE ADJUSTMENT-

,Drive unit in reverse on a level surface.

Move motion control lever to the right and forward

until it stops against reverse adjustment plate and release lever.

If unit "creeps" forward or backward, turn engine off and set parking brake.

,Loosen and move reverse adjustment plate in th_

same manner as forward adjustment plate described above:

Forward "creep", move plate backwards 1/16 inch. Reverse "creep", move plate forward t/16 inch.

Retighten bolts securely.

Repeat reverse drive test and, if necessary, readjus! until "creep" is eliminated,

tf "creep" cannot be eliminated by the above adjustments contact your nearest Sears Service Center,

FORWARD ADJUSTMENT PLATE

\BOLTS

 

MOTION

 

CONTROL

REVERSE ADJUSTMENT PLATE

LEVER

FiG. 28

2I

Page 21
Image 21
Sears 917.25559 Service AN Adjustments, To Adjust Motion Control Lever, Connector, Forward Adjustment, Reverse Adjustment