4. PullChokeout(Fig9). .
5 MoveThrottleControltomiddleposition(Fig°9)o
6.TurnIgnitionKeyto "START"positionuntilEnginestarts (Fig,9). NOTE:DONOTRUNSTARTERCONTINU-
OUSLYFORMORETHANFIFTEENSECONDSPER MINUTE°If enginedoesnotstartafterseveralattempts, moveThrottleControlto "F" (fast)position,waitafew minutesandtry again.
Thefirsttimeyoustarttheengine,it will take extra crank-
ing time to move fuel from tank to the engine.
NOTE: ALLOW ENGINE TO WARM UP FOR A FEW MINUTES BEFORE ENGAGING CLUTCH OF TRACTOR OR ATTACHMENT.
7.When restarting a warm engine, move Throttle Control mid_ way between "S" (slow) and "F" (fast) position. C_hoke
may not have to be used
OPERAT"ON
BEFORE DRIVING THE TRACTOR, IN-
STALL MOWER OR REMOVE FRONT
MOWER SUSPENSION ARM (FIG. 11).
CAUTION
1, Keep all shields in place,
2o Before leaving operator's position: a. Shif_ transmTssion to neutral
b. Depress Clutch/Brake Pedal and set Parking Brake.
€. Disengage Attachment Lever. d. Shut off engine.
e. Remove Ignition Key,
3.Wait for al! movement to stop before servicing machine.
4.Keep people and pets a safe distance away from machine,
5Always wear substantial footwear and avoid loose fitting clothing that could get caught in moving parts.
OUT THE DEFLECTOR SHIELD 1N
DO NOT OPERATE THE MOWER WITH-
PLACE.
NOTE: A SPARK ARRESTER MUFFLER (PAGE 30) IS
AVAILABLE AS AN ACCESSORY PART FOR YOUR TRACTOR, CHECK LEGAL REQUIREMENTS IN YOUR AREA.
STOPPING YOUR TRACTOR
1. Push | If | BRAKE | It | _ . |
|
| poslt_om |
2_ Place Parking Brake Lever in "ENGAGED _ position and re- lease pressure from
brake position. NOTE: MAKE SURE PARKING BRAKE WILL HOLD TRACTOR SECURE,
I1 | I! | _ , |
3o Move Shift Control Lever to NEUTRAL |
| position,, |
4, Place Attachment Clutch Lever in "DISENGAGED" posi- tion=
5 Move Throttle Control to "S" (slow) position.
6.Turn Ignition Key to "OFF" position. Never use Choke to stop Engine.
TOR TO PREVENT UNAUTHORIZED
USE.
REMOVE KEY WHEN LEAVING TRAC- !
TRANSPORTING YOUR TRACTOR
For pushing or towing your tractor, place Gear Shift Control
Lever and Range Shift Lever to | I! | N | 11 | . . |
|
| neutral posttton (Fig. 9). |
NOTE: DO NOT TOW YOUR TRACTOR FASTER THAN SIX MILES PER HOUR.
TRACTOR OPERATIION ON HH=LS
TRACTOR OPERATION
1,. With engine running and warm place Throttle Control mid-
way between | ii | S | II | (slow) and | I | F | I | , |
|
|
|
| (fast) pos=tton, |
2 Push
Shift Control Lever to desired gear and Range Shift Lever to "LO _ (Low) position (Fig 9)
1.Choose the lowest gear BEFORE starting up or down hills,
1
DO NOT DRIVE UP OR DOWN HILLS I
WITH SLOPES GREATER THAN 15 ° ,
AND DO NOT DRIVE ACROSS ANY
SLOPE. REFER TO PAGE 47.
3.Release
4o If ground travel is too slow, move Throttle Control to
"F" (fast) position or press
to a different gear.
NOTE: BRING TRACTOR TO COMPLETE STOP BE-
FORE SHIFTING GEARS. ALWAYS SELECT A GROUND TRAVEL SPEED THAT WILL SUIT THE TER- RAIN AND THE ATTACHMENT BEING USED°
NEVER PLACE YOUR HANDS OR FEET
IN OR UNDER ANY POWERED ATTACH-
MENT OR NEAR ANY MOVING PART
WHILE TRACTOR OR ANY POWERED
ATTACHMENT IS RUNNtNG.
2, AVOID STOPPING OR SHIFTING ON HILLS,
a, If slowing is necessary, move Throttle Control Lever to m_ddle position.
7
LEAVE ENOUGH ROOM WHEN
PING AND STARTING TO ALLOW
SLIGHT TRACTOR ROLL DOWNHILL AS
THROUGH CLUTCH POSITION,
b. tf stopping is absolutely necessary, push
Pedal quickly to brake position and engage Parking Brake.
CoTo restart your tractor, make sure tractor is in 1st gear and that you have allowed room to roll slightly down- hill Disengaga Parking Brake and release