ASSE BLY
CONNECT BATTERY (See Figs, 2 and 3)
| CAUTION: Do not short battery tern}i, | |||
...... i | rials. | Before | connecting | battery, re- |
| move | n}etai | bracelets, | wristwatch |
| bands, | rings, | etc. |
|
Positive terminal must be connected first to prevent sparking from acciden- tal grounding,
•Remove cardboard packing from seat pan and lift seat pan to raised position.
Open battery box door.
Remove terminal protective caps and discard.
,If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
•First con nect RED battery cable to positive (+) terminal with hex bolt, flat washer, lock washer and hex nut as shown. Tighten securely.
Connect BLACK grounding cable to negative
,Close battery box door. Open battery box door for:
•Inspection for secure connections (to tighten hard- ware).
oInspection for corrosion.
• Testing battery.
• Jumping (if required). o Periodic charging.
DISCARD TERMINAL PROTECTIVE
CAPS
LOCK
HEX WASHER
NUT
\\ FLAT
WASHER
HE×
BOLT
NEGATIVE (BLACK)CABLE
RG. 2
SEAT
PAN
BATTERY
BOX DOOR
FiG, 3
iNSTALL SEAT (See Fig, 4)
Adjust seat before tightening adjustment bolt.
-Remove cardboard packing on seat pan.
-Place seat on seat pan and assemble shoulder bolt.
=Assemble adjustment bolt, lock washer and flat washer loosely. Do not tighten.
•Tighten shoulder bolt securely.
Lower seat into operating position and sit on seat.
•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.
oGet off seat without moving its adjusted position. = Raise seat and tighten adjustment bolt securely,
SEAT
SEAT PAN
SHOULDER
BOLT
| FLAT WASHER | |
ADJUSTMENT | LOCK WASHER | |
BOLT | ||
| ||
| FIG, 4 |
8