![](/images/new-backgrounds/1096032/9603259x1.webp)
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause y tractorto run poorly,stop running, or preventit from starting.
• Check widng. See electrical wiring
diagram in the Repair Parts section,
TO REPLACE FUSE
Replace with 30 amp
REPLACING BAT'rERY
_kCAUTION: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch
bands, dags, etc.
Positive terminal must be connected first to prevent sparking from ecoldental grounding.
1.Lift hood to raised position.
2.Remove terminal guard.
3.Disconnect BLACK battery cable then
RED battery cable and carefully remove battery from tractor.
4.Install new battery with terminals in same position as old battery.
5.Reinstall terminal guard.
6.First connect RED battery cable to positive (+) battery terminal with hex belt and keps nut as shown. Tighten securely.
7.Connect BLACK grounding cable to negative
Tighten securely
8.Close terminal access doors.
9.Close hood.
Terminal | Keps. | Hex Bolt |
Access |
|
|
Door |
|
|
Terminal |
| (Red) |
|
| Cable |
|
| 3lack) |
|
| Cable |
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole In the backside of the grill.
4.Close hood.
TO ADJUST ATTACHMENT LIFT SPRING
1._Arniteholding spring bashing with wrench, loosen jam nut.
•Turn adjustment bolt clockwise to extend spdng and reduce llft effort f¢ heavier attachments.
•Turn adjustment bolt countemlockwi for lighter attachments.
2.Retighten jam nut against spring bushing.
IMPORTANT: Do not adjust for maxi-
mum spring tension when using light attachments such as a mower. Adjust li
lever spdng to aid in liftingattachment. Do not overpower spdng. When remo_ ing attachment, always adjust spring tension to its lowest position,
AdjustmentBolt
• _ Spring
Jam Nut
TO REMOVE HOOD AND GRILL ASSEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp ho< at sides, tit+,toward e_jine and lift _. of tractor.
4.To replace, reverse above preced=.
H°°p_adlightWlm
ector
3O