ASSEMBLY
UNPACKING CARTON
BECAREFUL OF EXPOSED STAPLES
WHEN HANDLING OR DISPOSING OF
CARTONING MATERIAL.
.... H,H,
CAUTION: WHEN UNPACKING AND ASSEMBLING
TILLER, BE CAREFUL NOT TO STRETCH
OR KINK CABLES,,
. Whileholding Handle Assembly, cut Cable Tiessecur-
ing Handle Assembly to Top Frameand DepthSlake°
LetHandle Assembly rest on Tiller.
• RemoveTop Frameof Carton.
• Slowly ease Handle Assembly up and place upside
down on top of Carton (Fig. 2).
FIGURE 2
•Cut down right hand front and right hand rearcorners
ofCarton, lay side carton wall down.,
•Remove packing materialfrom HandleAssembly,,
•Separate Shift Rodfrom Handle Assembly,
INSTALL HANDLE
•Insertone Handle Lock(with teeth facing OUTWARD)
in Gearcase Notch (Fig. 3). (Apply grease on smooth
side of Handle Lock to aidin keeping Lock in place
until Handle is lowered intoposition)°
GEARCASE GEARCASE
NOTCH
HANDLE
LOCK
Grasp Handle Assembly. Hold in "UP" position (Fig.
4), Be sure Handle Lock remains in Gearcase Notch,,
Slide Handle Assembly onto Gearcaseo
f,...-..= "UP" POSITION
"": "" ', ', _GF'_'_EN HANDLE
"_._ "',", ILOCK LEVER TO
_?'_ " "t HOLD
HANDLE ==,_'_. ', -, ....
z
FIGURE 4
• Rotate Handle Assembly down to install two Carriage
Bolts and Lock Nuts, Insert rear Carriage Bolt (Fig,,5)
first, with head of Bolt on L.H. side ofTiller, Lowerthe
Handle Assembly,,Tighten Bolts so Handle moves with
some resistance.
•Insert second Handle Lock (with teeth INWARD) inthe
slot-ofthe Handle Base (Fig,, 5)°
-Place Flat Washer on threaded end of Handle Lock
Lever.,
• Insert Handle Lock Lever through Handle Base and
Gearcase.
•With Handle Assembly in lowest position, securely
tighten Handle Lock Lever by rotating clockwise ((_)o
Leaving Handle Assembly in lowest position wilt make
iteasier toremove Tiller fromCarton,
GEARCASE HANDLE
LOCK
\
SLOT \/FLAT
c,BOLT / / .ANDLE
"_'_-.JJ_- _ _,./ LOCK
CARRIAGE / ? /
BOLT LOCKNUT
HANDLE LOCKNUT
BASE
FIGURE 3 FIGURE 5
7