![](/images/new-backgrounds/1058793/5879325x1.webp)
There are two motor safety filters: 1. a dark foam filter incorporated in the red frame and 2. a white electrostatic filter that is laid on the back side of the dark foam filter.
These filters should be checked with each bag change. The dark foam filter can be washed, per the instruct0ons below and the white filter must be replaced when dirty,
WARNING
Electrical Shock Hazard
Do not operate the cleaner without the motor safety filter. Be sure the filter is dry and properly installed to
prevent motor failure and/or electrical shock.
i,J
3.Peel the white filter off the dark foam filter as
shown° Lay a new white filter on the
dark filter by align- ing the notches in the filter with the legs of the frame.
ElectrostaticS" "_
Dark Foam
Filter
from wall outlet
and remove bag. t. Unplug cord
2. Pull out safety
_._' / I,_ filters as sh°wn.
The new filter can be purchased under part number 4369971 at your local Sears
Service Unit,
DARK FOAM FILTER
This filter and the frame can be washed in
warm soapy water, rinsed and air dried. DO NOT clean in a dishwasher or clothes
washer or install while damp,
WHITE ELECTROSTATIC FILTER
This filter must be replaced when dirty It should be replaced regularly depending on use conditions, The filter CANNOT be
washed as it will lose its dust trapping ability.
Unplug cord from wall outlet. Do not drip water on cleaner.
Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid detergent and water, then wrung dry Wipe dry after cleaning.
To reduce static electricity and dust build-
up, wipe outer surface of cleaner and attachments.
Wash attachments in warm soapy water,
rinse and air dry, Do not clean in dish- washer,
4. Snap filter back into canis- term
5. Insert bag,
DO NOT USE ATTACHMENTS IF THEY ARE
WET,
J• CAUTION ..............
Attachments used in dirty areas,
such as under a refrigerator, should not be used on other surfaces until
they are washed. They could leave marks,
13