DISASSEMBLY
A. DOOR
1.Loosen 3 screws holding an upper hinge to separate the door body. (Figure 7)
Figure 7
B. THERMOSTAT
1.Pull Knob Dial,
2.Loosen 1 screw holding the case and pull it out to remove the Therme cover. (Figure 8)
Figure 8
3.Pull out thermostat in the theremostat cover, and disconnect lead wires. (Figure 9)
NOTE : Replace a new thermostat with proper specification.
C. COMPRESSOR AND PTC
1.Remove Clamp, Protector Cover, Power Cord and Lead Wire first. (Figure 10)
2.Separate OLR
3.Separate PTC.
4.Remove the Compressor Base by loosening 4 bolts fixed to base plate of the set. (Figure 11)
Figure 10 | Figure 11 |
5.Remove the Compressor by loosening 2 earth screws next to Compressor.
NOTE : Replace the Compressor, after peeling off painted part of earth terminal.
•Compressor inhales the gas evaporated from Evaporator and condenses this gas and then delivers to Condenser.
•PTC is abbreviation of Positive Temperature Coefficient and is attatched to the Compressor, and operates motor.
•OLP prevents Motor coil from being started inside Compressor.
•Do not turn the Adjust Screw of OLP in any way for normal operation of OLR
@
Figure 9
