23
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, first unplug the power adapter.
Then, remove the right pedal, the seat post knob, the
seat post, the top shield cover, the rear shield cover,
the front shield cover, the right disc cover, and the right
shield (see the instructions below).
Using an adjustable wrench, turn the Right Pedal (21)
counterclockwise and remove it.
Next, remove the Seat Post Knob (27) and remove the
Seat Post (6).
Using a flat screwdriver, remove the Top Shield Cover
(8) and the Rear Shield Cover (9). Then, use the flat
screwdriver to release the Front Shield Cover (7).
Rotate the right Pedal Disc (17) clockwise to
release it from the Right Shield (10). Then, carefully
work the left Pedal Disc off the Right Crank Arm (19).
See the EXPLODED DRAWING near the end of this
manual and remove the M4 x 19mm Screws (44) and
the M4 x 25mm Screws (62) from the Right and Left
Shields (10, 11). Then, remove the Right Shield.
Next, loosen the M6 x 20mm Hex Screw (49). Then,
tighten the M10 x 50mm Hex Screw (48) until the Drive
Belt (54) is tight.
When the Drive Belt (54) is tight, tighten the M6 x
20mm Hex Screw (49).
Then, reattach the right shield, the right pedal disc, the
front shield cover, the rear shield cover, the top shield
cover, the seat post, the seat knob, and the right pedal.
Plug in the power adapter.
10
17
27
21
19
7
9
8
6
48
49
54