- HOW TO INSTALL YOUR HOME DRINKING WATER SYSTEM -
tighten the nut. NOTE: Cut tubing as needed for neat appearance, but keep long enough to alllow easy service of the RO system.
7. If needed, cut the 1/4" tubing (marked "1/4"
BARB ON FAUCET") to length. Then, push the end | faucet | base | |
all the way onto the 1/4" barb fiting on the faucet. | |||
| 1/4" barb | ||
|
| fitting |
8. Take the 27" long separate piece of 3/8" tubing and pass 1 end down through the faucet support.
Push the other end all the way onto the 3/8"barb fitting on the faucet.
9.Feed the faucet base leadwire down through the faucet support.
10.Lower the faucet and base down onto the faucet
support, carefully working the tubing and leadwire
through the support. Use the 5/8" long screw to
fasten base and support together. Insert the but-
ton, removed from the support in step 1, into the hole to cover the screw.
3/8" | barb |
|
|
fitting |
|
| |
washer |
|
| |
| tubing |
|
|
|
| 1/4" | tubing |
|
| (1/4" | BARB |
3/8" |
|
|
|
faucet | su | 318" tubing, | |
27" | long |
NOTE:FOREASE
OF SERVIC AND
MAINTENANCE,KEEP
TUBINGLENGTHSLONG
ENOUGHSOREMOVALOF
THERO SYSTEMFROM
UNDERTNt5SINHIS
POSSIBLE.
button
faucet base
leadwire
STEP 4 -- MAKE ELECTRICAL, AND REMAINING TUBING CONNECTIONS
A. INSTALL BATTERY PACK iN ELECTRONIC | nectors together. Place the battery pack inside the | |||||
|
|
| ||||
BOX. |
|
| electronic | box and install | the | back cover. |
1. Looking at FiG. 7, page 10, | remove | the rubber | 4. Reinsert | the electronic | box | and postfilter into the |
retainer holding the electronic | box and | postfilter in | holder bracket. |
|
| |
the holder. |
|
|
|
|
|
|
2.Pull the electronic box from the holder and remove the back cover.
3.Fasten the battery pack (BE SURE BATTERIES ARE INSTALLED CORRECTLY, AS SHOWN ON THE BATTERY HOLDER) and electronic box con-
5.Replace the rubber retainer around the holder.
continued on next page
9