Overview:
Camera
Set screw
Dome cover
Models ending in
NVWQ or PVWQ only.
Zoom 
Focus
Wiring notch |
|
|
| Female BNC connector | |||||||
|
|
|
|
|
|
|
|
|
| DC plug with | |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| terminal block |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Mounting screw
DC jack Mounting base
Important:
Do not cut the DC jack or the female BNC connector as this will void the warranty.
Before Starting:
1.Please read this manual carefully and keep it for future reference.
2.Use the camera within given temperature and electricity limits.
3.Do not point the camera at the sun. Heat could damage the camera, even when not in use.
4.Do not mount the camera in areas exposed to radiation, strong magnetic fields, or strong electrical signals*
5.Do not drop the camera or subject it to strong vibrations.
Note: Many video monitors produce strong electromagnetic fields close to the display CRT, especially when the monitor is turned on or during
Installation:
1.Run hidden cables from the video source and 12VDC power supply to the camera. Do not cut the DC jack or the female BNC connector as this will void the warranty. If needed, use the included
2.Test to make sure the voltage is correct. Use only 12VDC.
3.Undo the 3 set screws on the side of the dome cover using the included allen wrench and remove the dome from the base.
4.Hold the camera against the wall, ceiling, or other mounting surface while watching the monitor to find the best mounting location. Mark that location with a pencil.
5.If the installation involves surface wiring, use the wiring notch located on the side of the mounting base
to run wires.
6.Mount the mounting base to the wall using the 3 included mounting screws. If necessary, use the included screw anchors.
7.Adjust the camera angle as shown on page 2, Adjusting the Camera Angle.
8.Test the video signal.
9.Models ending in NVWQ and PVWQ only: Adjust the zoom and focus by hand or with a small screwdriver to loosen the knob, and then sliding the knob left or right. IMPORTANT: Do not use power tools. Lens damage may result.
10.Reattach the dome to the camera.
11.Use the included allen wrench to tighten the set screws, securing the dome to the base.
12.Do a final test of the video camera and monitor.
3 |
