Via the “Sensitiv” menu, adjust the transmitter’s input sensitivity (see “Adjusting the sensitivity (transmitter only)” on page 64).
Connecting the headphones/monitoring the audio signal
Neue
Abbildung
To monitor the audio signal, connect headphones with a ¼” (6.3 mm) jack plug to the headphone output (PHONES) .
Attention! High volume!
Even short exposure to high volume levels will damage your hearing! Set the volume for the connected headphones to the minimum before putting the headphones on.
First, set the volume control to the lowest volume by turning it to the left as far as possible. Then gradually turn up the volume.
Volume up? – NO!
When people use headphones, they tend to choose a higher volume than with loudspeakers. Listening at high volume levels for long periods can lead to permanent hearing defects. Please protect your hearing, Sennheiser headphones have an excellent sound quality even at low volumes.
Service interface
The service interface | is only required for servicing purposes. |
19” rack adapter and antenna mount
For mounting one or two transmitters into a 19” rack, you require the GA 2 rack adapter (available as an accessory). The GA 2 rack adapter consists of:
y 2 rack mount “ears” y 1 connecting bar y 1 connecting plate
y 2 covering plugs for antenna holes
y12 recessed head screws M 3x6
y2 recessed head screws M 6x10
When mounting only one transmitter into a rack, you can use the AM 2 antenna mount (available as an accessory) to mount the transmitter’s antenna connection to the front of the GA 2 rack adapter. The AM 2 antenna mount consists of:
y 2 BNC extension cables
y2 nuts
49
