IMPORTANT! Notes:
ST-FOC
LTD
HI-BST
Sensitiv
yIf the squelch threshold is adjusted too high, the transmission range will be reduced. Therefore, always adjust the squelch threshold to the lowest possible setting.
yWhen in the setting mode of the “SQELCH” menu, pressing the button for more than three seconds will switch the squelch off.
“SQ.OFF” appears on the display. If no RF signal is being received, his- sing noise will occur. This setting is for test purposes only.
Stereo/FOCUS selection (receiver only)
Via the
In both operating modes, the SR 300 IEM G2 stereo transmitter has to be set to stereo operation.
When the receiver is set to stereo operation, the
When the receiver is set to FOCUS operation, the
the mixed mono signal (see “Adjusting the balance” on page 53).
Limiting the volume at the headphone output (receiver only)
Via the “LTD” menu, you can switch the limiter on and off. With the limiter switched on, the volume at the headphone output will be reduced.
Activating/deactivating the frequency boost (receiver only)
Via the
Adjusting the sensitivity (transmitter only)
To match the transmitter to the output level of the connected unit (e.g. mixing console), you can adjust the input sensitivity in four steps of 8 dB via the “Sensitiv” menu.
The input sensitivity is adjusted too high when close talking distances, speakers with loud voices or loud music passages cause overmodulation in the transmission link. In this case, the transmitter’s “PEAK” warning will light up and the receiver’s level display for audio signal “AF” will show full deflection.
If, on the other hand, the sensitivity is adjusted too low, the transmission link will be undermodulated, which would result in a signal with high background noise.
The sensitivity is correctly adjusted when the level display for audio signal “AF” shows full deflection only during the loudest passages.
64