| In case of difficulty |
| If problems occur that are not listed in the below table, please contact your Sennheiser agent. |
|
|
| Problem | Possible cause and what to do |
|
|
| Communications in one ear only | You are using a stereo intercom system but the headset is set to mono operation. |
| (HME 100, HME 110) | Set the Mono/Stereo switch to ‘Stereo’. |
| |
| You are receiving a mono source but the headset is set to stereo operation. |
| Set the Mono/Stereo switch to ‘Mono’. |
|
|
| Very low volume communication | The volume control is set too low. |
| Check the volume setting of the headset. |
| The headphone connection has been pulled out. |
| Check to see if the headphone jack plug is correctly connected. |
| Reduced intelligibility | The microphone connection has been pulled out. |
| Check to see if the microphone jack plug is correctly connected. |
|
|
Microphone output voltage too high or | |
| too low | To do so, use a small slotted screwdriver and turn the ‘Mic Gain Adjustment’ screw (see |
| |
| illustration on page 14) until you have reached the desired setting. |
|
|
17