
English |
Adjusting the volume
Set the volume of your sound source to a medium value. With some devices, the volume for the headphone output can be regulated separately.
Use the VOLUME control on the right earpiece to adjust the headphones´ volume.
Adjusting the receiver channel
First switch on the transmitter (see section Where to place the transmitter). Then switch on the headphone receiver - as soon as the receiver is switched on it automatically tunes itself to the
first strong signal found (normally the transmitter frequency). If, for some reason, the selected channel is not the correct one (eg: because of
interference or another nearby system), press the TUNE button on the earpiece and the
Changing the transmission channel
To avoid interference caused by the simultaneous
operation of several transmitters, select a | |
different channel on each transmitter. Depending | |
on the system variant, two or three switchable | |
transmission channels are available. |
|
To select a channel, press the CHANNEL button until | |
the desired LED or LED combination |
|
lights up: |
|
LED 1 | channel 1 active |
LED 2 | channel 2 active |
LED 1 and 2 | channel 3 active (except 863 MHz version). |
Complete freedom of movement
It is not necessary that transmitter and headphone receiver are in a direct line of sight, so you can move around freely in the home or outside in the garden. One transmitter can be used to transmit to several receivers on the same frequency.
Additional headphones with the designation HDR 65 are available from your specialist dealer. Please make sure to choose headphones with the
same frequency range as the transmitter you are using (see type plate on the bottom of the transmitter).
Wireless RS