ew500_SK.book Seite 42 Dienstag, 4. November 2003 4:02 16
Preparing the bodypack transmitter for use
Inserting and replacing the batteries
For powering the transmitter, two 1.5 V AA size batteries are required.
Press the two unlocking buttons | and open the |
battery compartment cover . |
|
Insert the two batteries as shown above. Please observe correct polarity when inserting the batteries.
Close the battery compartment. The battery compartment cover locks into place with an audible click.
Inserting and charging the accupack
The transmitter can also be powered via the rechargeable Sennheiser BA 2015 accupack. Insert the accupack into the battery compartment as described above.
The transmitter has two charging contacts and a sensing contact on its short sides. The accupack can be recharged while remaining in the transmitter. Insert the transmitter into the L 2015 charger (see operating manual of the L 2015 charger).
Note:
For accupack operation of the transmitter, only use the BA 2015 accupack in order to ensure optimum operational reliability. For charging the accupack, only use the L 2015 charger. Both the accupack and the charger are available as accessories.
The accupack is fitted with an integrated sensor which is
–via a third contact – monitored by the electronics of the transmitter and the charger. The sensor is necessary for the following control purposes:
y The taking into account of the different voltage characteristics of primary cells (batteries) and accupacks. The battery status indications on the
42