Synchronizing the bodypack transmitter with a receiver

Synchronizing the bodypack transmitter with a receiver

When synchronizing the bodypack transmitter with a receiver, please observe the following:

￿Only use a transmitter and a receiver from the same frequency range (see the type plate on the transmitter and the receiver).

￿Make sure that the desired frequencies are listed in the enclosed frequency information sheet.

￿Make sure that the desired frequencies are approved and legal in your country and, if neces- sary, apply for an operating license.

Synchronizing the bodypack transmitter with the receiver – individual operation

Upon delivery, the bodypack transmitter and the receiver are synchronized with each other.

If, however, you cannot establish a transmission link between bodypack transmitter and receiver, you have to synchronize the channels of the devices.

For information on automatic synchronization of the body- pack transmitter with the receiver (individual operation), refer to the instruction manual of the receiver. This infor-

mation is marked with the icon.

Alternatively, you can set the channel on the bodypack transmitter manually:

￿Make sure that you set the bodypack transmitter to the same frequency bank and the same channel as the receiver (see page 22).

If you still cannot establish a transmission link, refer to the chapter “If a problem occurs ...” on page 31.

Synchronizing bodypack transmitters with receivers – multi-channel operation

Combined with ew 500 G3 receivers, ew 500 G3 bodypack transmitters can form transmission links that can be used in multi-channel systems.

For information on automatic synchronization of bodypack transmitters with receivers (multi-channel operation), refer to the instruction manual of your receiver.

For more information on multi-channel operation, visit the SK 500 G3 product page at www.sennheiser.com.

28