Sennheiser SKM 1032 manual How to adjust the transmitter frequency

￿

￿

￿

￿ ￿

How to adjust the transmitter frequency

Adjust the desired transmitter frequency with the switch ￿. Each number on the switch corresponds to a transmitter frequency. You will find the exact frequency on the type plate in the battery compartment.

￿Take care that the transmitter frequency and the received frequency selected at the receiver do correspond.

￿A small screw driver (breadth approx. 2 mm) or the end of the wire antenna which is shaped like a small blade is suitable tools for the selection.

How to switch on / how to select sensitivity

The ON/OFF-switch ￿and the selector switch ￿are positioned in a cavity on the bottom of the housing.

￿The ON/OFF-switch which is used more frequently is positioned slightly above the selector switch.

After having switched on the transmitter you must wait approx. 2 seconds as the transmitter requires this time for adjusting to the chosen frequency. (PLL-rest.).

The AF signal is attenuated if the selector switch for the sensitivity ￿ is switched to „LOW“. Close-miking can thereby not result in overmodulation.

￿Attenuation for SKM 1030: approx. 14 dB

￿Attenuation for SKM 1032: approx. 20 dB

18