Sennheiser SKM 500 Cleaning the radio microphone, Dry the foam insert, Remove the foam insert, Reinsert the foam insert, Cleaning the radio microphone

Cleaning the radio microphone

Cleaning the radio microphone

CAUTION! Liquids can damage the electronics of the radio microphone!

Liquids entering the housing of the device can cause a short-circuit and damage the electronics.

Keep all liquids away from the radio micro- phone.Use a cloth to clean the radio microphone from time to time.Do not use any solvents or cleansing agents.To clean the sound inlet basket of the microphone head (MMD 935-1, MMD 945-1):

Unscrew the upper sound inlet basket from the microphone head by turning it counterclockwise (see diagram).

CAUTION! Liquids will damage the microphone module!Liquids will damage the microphone module.Only clean the upper sound inlet basket.Remove the foam insert.To clean the sound inlet basket:–Use a cloth to clean the upper sound inlet basket from the inside and outside.

OR

–Scrub with a brush and rinse with clear water.

If necessary, clean the foam insert with a mild detergent or replace the foam insert.

Dry the upper sound inlet basket.Dry the foam insert.Reinsert the foam insert.Replace the sound inlet basket on the microphone head and screw it tight.

You should also clean the contact rings of the microphone head from time to time:

Wipe the contact rings of the microphone head with a cloth.

For information on cleaning the MMK 965-1 microphone head, refer to its instruction manual.

27