Servis-Rhino 4211SS manual Assembly, Dismounting Loader and Mounting Loader to Tractor

ASSEMBLY

Dismounting Loader and Mounting Loader to Tractor

To avoid injury during installation of loader:

•Place loader bucket against barrier to restrict forward movement of loader.

•Do not permit bystanders within 15 feet of loader.

Loader must be equipped with a bucket or other optional attachment to dismount from tractor.

When dismounting loader, maintain clearance between loader side frames and tractor hood and front axle.

Dismounting Loader

1.Locate tractor and loader on firm level ground.

2.Level and lower bucket to ground. Rotate bucket down slightly to remove pressure on hitch pins (See Figure Asm-L-0037).

3.Rotate parking stands from storage position to operation position by removing linch pins and clevis pin. Inner tube of parking stand is now free to slide within outer tube. Reinstall clevis pin and linch pin when parking stands are in operation position. See Figure Asm-L-0001.

4.Remove lynch pins and hitch pins from mounting.

5.Start tractor engine and release brakes. Retract lift cylinders, allowing parking stands to support weight of loader. Drive tractor forward slightly so parking stands are firmly positioned. Operate loader control lever to extend lift cylinders, allowing top of loader upright to rotate forward out of upper mounting saddle. Operate loader control lever to retract bucket cylinder, which will curl bucket backward causing the loader upright to lift off of the mounting shaft. Continue to curl bucket until loader upright has rotated upward from the mounting position to clear front tires or fenders on tractor.

6.Stop engine and apply brakes. Disconnect hydraulic hoses from tractor.

7.Start tractor engine and release brakes. Slowly back tractor out of loader.

4211-4211SS 01/11 Assembly Section 3-5

© 2011 Alamo Group Inc.

ASSEMBLY