Model EP730

7.2 V DC

SharkCordless Hand VacBEFORE USE
1.This cordless vacuum is powered by rechargeable nickle-cadmium batteries.
Before using the vacuum, charge the vacuum cleaner for a minimum of 16 hours.
NOTE: Ensure that the On/Off Switch (#11) is on the “Off” position before
charging.
2.The normal full charging time for this vacuum is 16-20 hours. The vacuum cleaner
will run for full operation time is it has been fully charged. Do this by running the
vacuum cleaner until it stops, then fully recharge the battery.
3.Store the vacuum cleaner on the charging base when not is use so that it is always
charged and ready to use.
CHARGING YOUR CORDLESS VACUUM
1.Place the charging base (#14) near an electrical power outlet and plug in.
2.Place the unit on the charging base (#14). The charging light indicator (#9) will
shine red to indicate that the vacuum cleaner is properly positioned on t=on the
charging base and that the unit is being charged.
NOTE: Ensure that the On/Off Switch (#11) is on the “Off” position before
charging.
3.Always return the unit to the charging base (#14) immedieately after use so that it
will be ready and fully charged for the next time.
NOTE: Peak performance may only be realized after the unit has been
charged and discharged two (2) or three (3) times.
IMPORTANT: To maintain peak performance of your cordless hand vacuum,
it is recommended that the unit be fully discharged, then
completely re-charged at least once a month.
8. Dust Cup Release Button
9. Charging Light Indicator
10. 180°Swivel Handle
11. On/Off Switch
12. Lower Housing
13. Charging Plug
14. Charging Base
1. Nozzle
2. Dust Cup Compartment
3. Dust Cup Filter
4. Ventilation Slots
5. Battery
6. Battery Compartment
7. Crevice Tool
ASSEMBLY
Note: Dust cup filter (#3) must always be used when operating the hand vacuum.
1. To open the dust cup compartment (#2), push the dust cup release button (#8) and
remove the dust cup compartment (#2).
Verify that the dust cup filter (#3) is inside, then re-attach the dust cup container
(#2) to the hand vacuum.
2. The crevice tool (#7) is located inside the swivel handle (#10). To attach the crevice
tool (#7) to the Hand Vacuum, remove from inside the handle and insert the large end
of the crevice tool into the nozzle (#1).

NOTE: Cordless vacuum Model EP730 is shipped with the

batteries uncharged. Charging of the unit for 16-20

hours prior to first use is required.

2

1