PRECAUTIONARY MEASURES
Important: If the suction opening of the unit, the hose or the chrome telescopic tube are BLOCKED, switch off the vacuum cleaner and remove the blocking substance before you start the unit again.
OPERATING INSTRUCTIONS
Flat & Upright Parking Position
Please note that your vacuum cleaner | Parking |
can be conveniently placed in a space | Position |
saving vertical parking position. | Bracket |
For vertical parking position, place the |
|
1.Do not operate the vacuum cleaner too close to heaters or radiators.
2.Before inserting the power plug into the wall outlet, make sure that your hands are dry.
3.Before you start vacuuming, make sure to remove large or sharp objects that might damage the vacuum.
4.When pulling out the power plug from the wall outlet, pull the plug not the power cord.
5.Do not pick up anything that is burning or smoking such as cigarettes, matches or hot ashes.
6.Do not use without all filters and paper dust bag in place.
Note: This vacuum cleaner is equipped with a plug and power cord that retract automatically. If the cord or plug get damaged, it must be replaced by a qualified technician.
Warning: Hold the plug when rewinding the cord. Do not allow
the cord to whip when rewinding.
vacuum on its side and slide the |
| Parking | ||||
parking position bracket that is on the |
| Position | ||||
telescopic tube into the parking |
| Support | ||||
position support that is on the |
|
|
| |||
underside of the vacuum. (Fig. 18) |
| Fig. 18 | ||||
|
|
|
|
| ||
|
|
|
|
| ||
|
| TROUBLE SHOOTING GUIDE | ||||
|
|
|
|
|
| |
|
|
| TROUBLESHOOTING GUIDE |
| ||
|
|
|
|
|
| |
| PROBLEM |
| POSSIBLE REASON | POSSIBLE SOLUTION |
| |
|
| 1. | Hose, wand or inlet is | 1. | Check for blockage - remove it. |
|
|
| 2. | If dust bag is full, replace dust |
| ||
| Motor runs but no |
| blocked. |
| ||
|
|
| bag. |
| ||
| 2. | Check bag full indicator. |
|
| ||
| suction | 3. | Insert hose clamp into hose inlet |
| ||
| 3. | Hose clamp not assembled to |
| |||
|
|
| until "snap" locks for proper |
| ||
|
|
| hose inlet properly. |
|
| |
|
|
|
| assembly. |
| |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| 1. | Cord twisted. | 1. | Pull cord out, straighten and |
|
| Cord does not |
| rewind again. |
| ||
| 2. | Cord pulled out too far - | 2. | Holding the plug, press the |
| |
| rewind |
| ||||
|
| beyond "RED" mark. |
| rewind button and try to rewind |
| |
|
|
|
|
| ||
|
|
|
|
| again. |
|
|
|
|
|
|
|
|
|
| 1. | Not firmly plugged in. | 1. | Plug unit in firmly. |
|
|
| 2. | No electricity in wall outlet. | 2. | Check fuse or breaker. |
|
| Cleaner won't run | 3. | Blown fuse/tripped breaker. | 3. | Replace fuse/reset breaker. |
|
|
| 4. | Motor thermostat may have | 4. | Allow unit to cool down before |
|
|
|
| tripped. |
| trying to switch "ON" again. |
|
|
|
|
|
|
|
|
| Turbo brush does | 1. | Rotating brush or elbow | 1. | Clear obstrucitons. |
|
|
| obstructed. |
| |||
|
| 2. | Clear obstruciton. |
| ||
| not rotate or | 2. | Hose obstructed. |
| ||
| 3. | Replace dust bag. |
| |||
| rotates slowly | 3. | Dust bags full. |
| ||
| 4. | Replace filters. |
| |||
|
| 4. | Filters need changing. |
| ||
|
|
|
|
| ||
|
|
|
|
|
|
|
3 | 8 |
|
