OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Replacing the Filters
Warning: To reduce the risk of electric shock, the hose, power
nozzle power cord and the power cord must be disconnected before changing the bag or performing maintenance/ troubleshooting.
Changing & Cleaning the
Your vacuum is equipped with a filtration system to reduce dust and pollen in your home as you clean. The
This is a rinseable filter but should be replaced every six (6) months. Never operate the vacuum without ALL the filters in place
To remove, open the dust bag compartment cover and pull the pre- motor assembly out of the vacuum. Remove the filter from the filter assembly. Rinse in lukewarm water and let it air dry completely for 24 hours. Do not use a washing machine to rinse the filter. Do not use a hair dryer to dry it. Air dry only. When the
Filter
Fig. 16
Changing & Cleaning the HEPA- Type Post Motor Filter
The
•Push the Power On/Off button to the "Off" position and disconnect the power cord from the wall outlet.
•The
•Hold the
•Replace with a new
Fig. 17
Filter
Motor Thermostat
Important: This unit is equipped with a motor protective thermostat. If for some reason the vacuum cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur:
• | Push the On/Off button once. |
• | Disconnect the plug from the |
| power source. |
• | Check the source of overheating |
| problem. (i.e. clogged hose or |
| filter) |
• If clogged hose or filter is found, | |
| unclog the hose and replace the |
| filters. |
• | Wait at least 45 minutes before |
Assembling Your Vacuum Cleaner
Note: Always remove the power plug from the wall outlet before assembling or removing accessories.
Attaching the Flexible Hose into the Vacuum
•Connect the flexible hose into the flexible hose inlet. Push in until you hear a “click”, indicating it is in its locked position. (Fig 1)
•Connect the hose connecting power cord from the flexible hose to the power cord receptacle that is on the unit just underneath the handle. (Fig. 1)
•To remove the flexible hose first remove the power nozzle power cord from the receptacle for the power nozzle power cord, then depress locking button and remove hose.
Power cord receptacle
Fig. 1
Fitting the Telescopic Tube to the Curved Wand / Hose Extension
•Push the extension tube into the curved wand / hose extension, as shown in the illustration below. Make sure that the extension tube locks in place. (Fig. 2)
Fig. 2
Extending the Chrome Telescopic Tube
Fitting the Floor to Carpet Brush to the Telescopic Tube
•Push the telescopic tube into the floor brush as show in Fig. 4.
Telescopic
Tube
Floor to Carpet
Nozzle
Fig. 4
Using Power Nozzle
Connecting the power nozzle to the telescopic tube:
•Depress the button on the telescopic tube and insert it into the slot on the power nozzle elbow.
•Push the telescopic tube down until you hear a "click". (Fig. 5)
Telescopic
Tube
Power
Nozzle
Fig. 5
•Insert the power nozzle cord plug into the power socket on the flexible hose. (Fig. 6)
•To start power nozzle press the On/Off button that is located on the power nozzle.
attempting to reuse the vacuum. |
• After unit has cooled down for |
45 minutes, plug in the cleaner |
and push the On/Off button. The |
vacuum should start again. |
• If the vacuum still does not start, |
contact customer service at |
1 (800) |
•Push forward on the plastic button and pull the inner chrome tube outward. (Fig. 3)
Plastic Fig. 3 Button
Fig. 6
7
4
