Shark MV3010 manual Using Steam Mode

Steam Mode

Fig. 29

1

2

3

Dust

Fig. 30

Mop

Scrub

USING STEAM MODE

NOTE: You should vacuum your bare floors before you steam them.

1Twist the quick release cord holder to unwrap the power cord completely and plug in the unit. The LED lights on the steam nozzle will begin to flash blue in a chasing manner. (Fig. 29)

2To begin steaming, step gently on the foot pedal once to enter DUST mode (1). The DUST light on the until will appear solid blue. DUST setting is a light steam for a quick dusting and fastest dry time.

To switch to MOP mode (2), step on the foot pedal a second time. The MOP mode light will appear solid blue. MOP setting is for normal, everyday steam cleaning.

To switch to SCRUB mode (3), step on the foot pedal a third time. The SCRUB mode light will appear solid blue. SCRUB setting is for heavy cleaning.

MV3010_40_ENG_IB_120703_1.indd 9

3After selecting the preferred mode, place your foot lightly on the top of the steam nozzle and tilt the handle back. Begin mopping in a backward and forward motion. (Fig. 30)

To return to standby mode step on the pedal again until the LED lights are flashing blue in a chasing manner.

QUICK TIP: The steam mode (DUST, MOP, SCRUB) can be switched while actively steaming or while the unit is at rest.

IMPORTANT: Do not use the mop without attaching a multi-purpose cleaning pad and adding water to the tank first. When you are using the steam nozzle head for the first time, it might take longer than the 30 seconds to start steaming. You will not notice any visible steam until the steam mode is chosen and the handle is tilted back.

NOTE: Check water level and fill anytime throughout the cleaning process to maintain optimal steam.

www.sharkclean.com 9

12-07-03 9:16 AM