Shark NV356Q manual Mode 1 Upright Vac, To USE, To Assemble

Mode 1: Upright Vac

To reduce the risk of electric shock, unplug the unit before assembling, adding or removing attachments or converting modes.

WARNING: The On/Off switch is on the top of the Lift-Away®canister. Always ensure the power is OFF (“O” position) before plugging and unplugging.

	b	d
		a
Upper Cord		e
Storage Wrap

c

Suction

Release Collar

c

Release suction for easier push & pull on high pile carpets and area rugs.

b

a

Fig. 12

Fig. 13

Fig. 9 Fig. 10

Fig. 11

TO USE:

1Rotate the cord release to quickly release the power cord.

2Secure the power cord in the cord hook.

= Brush Roll ON

4	Gently press the floor nozzle down with your foot
	while you grasp the handle and tilt it back towards
	you. (Fig. 13)
	NOTE: The rotating brush on the motorized
	floor brush will not spin unless the nozzle is flat
	against the floor and the handle is tilted back.
5	Due to the huge suction power of this

TO ASSEMBLE:

1Place the floor nozzle on a level surface.

2Align the tube of the floor nozzle with the tube on the Lift-Away®canister and lower until you hear the two pieces click into place. (Fig. 9)

When attaching the motorized floor brush, ensure that the latching mechanism is fully locked in place to ensure electrical connection has been made.

3Attach the end of the extension wand to the tube on the back of the Lift-Away®canister until it clicks into place. (Fig. 10)

4Slide the accessory holder (a) positioned opposite the upper cord wrap, over the extension wand. Align the tab with the groove and push down.

(Fig. 11)

8

5Push the handle (b) onto the top of the extension wand until you hear it click into place. (Fig. 11)

6Insert the end of the stretch hose (c) into the connector on the back of the Lift-Away®canister. (Fig. 11)

7Store the dusting brush (d) and the crevice tool

(e)on the mounts of the accessory holder.

(Fig. 11)

= Bare Floor

= OFF

3Press the On/Off switch (a) to the “I” position to vacuum bare floors (straight suction only) or to the “II” position to engage the motorized floor brush (for vacuuming carpets and rugs). (Fig. 12)

IMPORTANT: The motorized brush indicator light

(b)will illuminate green when motorized floor brush is on, or red if there is a blockage or jam. (Fig. 12) This feature is designed to protect your Lifetime Belt that powers your motorized floor brush. See Checking for Blockages on page 15.

vacuum, it may become necessary at

times to adjust the suction release (c) on

the handle. (Fig. 11) If the vacuum seems

difficult to push or pull or if it is lifting

up area rugs, adjust the suction release

by rotating the collar 90° counterclockwise

to open the valve. Rotate the collar

clockwise to close the valve when you need

high suction and for vacuuming floors.

6 Empty dust cup after vacuuming and periodically

during use when it appears full. (See

“Maintenance” section for instructions.)

7 When you are finished vacuuming, turn the

vacuum off.

9