Using Your Light & Easy™ Steam Mop

 

When you use your steam mop for the

 

first time or if you have not used the unit

 

in awhile, it may take a minute or two

 

for the water to travel through the pump

 

and into the heater to create steam. Get

 

it started by pumping the handle a few

 

times. If you have waited a few minutes

 

and you still do not see any steam,

fig. 1

reference the troubleshooting section

 

on page 10.

fig. 2

fig. 3

IMPORTANT: Your steam mop needs water to make steam! Never use your steam mop without water in the tank.

Sweep or vacuum your floors prior to cleaning with your Light & Easy™ Steam Mop.

Visit www.sharkclean.com for other great quick cleaning products to complement your Light & Easy™ Steam Mop, such as the Shark® Navigator.

1Pull and twist the quick release cord holder to unwrap the power cord completely. (fig. 1) Plug into a 120-volt electrical outlet. (fig. 2) The “On” light will turn blue. If the light does not turn on, reference the troubleshooting section on page 10. (fig. 3)

6

TOLL FREE: 1-800-798-7398

S3251_11_ENG_IB_101117.indd 6

10-11-17 1:58 PM

Page 12
Image 12
Shark S3251 manual Using Your Light & Easy Steam Mop, Reference the troubleshooting section