Shark S3401 manual Using Your Hand Steamer, Care of Your Hand Steamer, After Use And Storage

Using Your Hand Steamer

fig. 1

Care of Your Hand Steamer English

fig. 4

fig. 2

fig. 3

AFTER USE AND STORAGE

1 When you have finished using the

fig. 5

CARE OF YOUR MICRO-FIBER CLEANING PAD & BONNET

IMPORTANT: Your hand steamer needs water to make steam! Never use your hand steamer without water in the tank.

Remove any large debris from the surface prior to cleaning with your hand steamer.

Visit www.sharkclean.com for other great steam cleaning products to complement your hand steamer.

1Plug into a 120-volt electrical outlet (fig. 1). The “On” light will turn blue. If the light does not turn on, reference the troubleshooting section on page 6.

2Wait 30 seconds for the boiler to heat the water. Pump the handle a few times to prime the pump, activate steam and moisten the micro-fiber pad (fig. 2).

3Pump the handle as you clean your sealed surfaces to customize steam output.

Shark® Handheld Steam Scrubber,

unplug the cord from the outlet and

stand the hand steamer upright as

you would an iron. Let the unit cool

2-3 minutes.

2Carefully separate micro-fiber cleaning pad or bonnet from steam cleaner (fig. 3).

3Empty the water tank before storage. Open the water tank cap and empty the tank over a sink. Close the water cap (fig. 4).

4Wrap the power cord completely around the base of the hand steamer (fig. 5).

1Wash pads in warm water. Wash separately from other laundry. Only use liquid detergent (no powder detergent). Do not use fabric softeners. Line dry or dry on a low dryer setting.

2If there are loose threads on the pad carefully cut the threads with scissors. Do not pull on them or cut at the base

IMPORTANT: The micro-fiber cleaning pad may be very hot from the steam. Use caution when removing. Let the unit cool for 2-3 minutes.

4 TOLL FREE: 1-800-798-7398

www.sharkclean.com 5