Shark S3501C manual Quick Start, Rt Quick

Quick Start

When assembling your steam mop there may be a little water in or around the water tank. This is because we test all our steam mops 100% before you buy them, so you get a quality Shark® Steam Mop.

12

5

QUICK TIP: For easier pushing and pulling, extend the handle length

DIRT CAN’T HIDE ON EITHER SIDE! All new design allows for optimal cleaning! When one side of the pocket gets dirty, just turn the mop head over and clean with the other side of the pocket.

rt Quick

3

4

6

ASSEMBLE

1Insert the mop handle into the pump actuator (the tube that leads to the tank). Push the mop handle and pump actuator together in until you hear it click into place.

2Select a mop head and cleaning pad. Fit one side of the pocket onto the head first, then using the lavender loop, pull the pocket over the head. Attach the quick fasteners on the top of the pocket to secure in place.

3Snap the mop head into the base to secure it. Press the release button to exchange mop heads.

FILL

4Lay the mop on the floor or on a counter top and remove the water tank cap by turning counter clockwise. Fill the water tank using the filling flask. Do not overfill the water tank. Replace the water cap and tighten.

IMPORTANT: Make sure your floors are sealed. Before using the Steam Mop consult page 3 for more information.

PREPARE

5For your comfort, you can adjust the height of the mop. Just lift the latch on the tube 90 degrees to the open position. Holding the handle, extend the tube to the height that’s right for you and then close latch to locked position.

6Plug in mop and wait 30 seconds or less for the mop to heat up. Pump the handle of the mop by pushing downward about 10 to 12 times to create steam.

NOTE: Steam is created automatically when you start mopping.

QUICK TIP: We’ve added additional mop heads for your convenience. Each mop head can be used on your floors. The Triangle Mop Head was specifically designed to reach into those tight corners and spaces, especially those found in the bathroom. The XL Mop Head was designed to make quick work of large open spaces. The Rectangle Mop Head is completely versatile.

NOTE: Do not leave your Steam Mop unattended during use.

IMPORTANT: Never leave the steam mop in one spot for any period of time with a damp or wet micro-fiber pocket attached as this will damage your floors.

TOLL FREE: 1-866-826-6941

www.sharkcompany.com