Shark V1940Q Operating Instructions, Assembling Your Cordless Sweeper, Charging Instructions

Charging

Light

Indicator

Fig. 5

OPERATING INSTRUCTIONS

ASSEMBLING YOUR CORDLESS SWEEPER

Your cordless sweeper will require very little assembly. You should remove it from the carton and familiarize yourself with all the components listed per the exploded view drawing on page 2. This will help you in the assembly and operation of your cordless sweeper.

NOTE: The charging adapter and lower handle may be shipped inside the dust cup or the packaging.

1.Insert the lower handle - small end - into the sweeper power head. Push until firmly in place. (Fig. 1)

Lower

Handle

Fig. 1

2.Assemble the handle by inserting the lower handle extension tube into the lower handle. Push until you hear it snap into place. Next, push the plastic folding pivot onto the lower handle extension tube until you hear them snap into place. Finally, insert the upper handle into the folding pivot until you hear it snap into place. (Fig. 2)

Fig. 2

3

OPERATING INSTRUCTIONS

3.To fold the handle, press on the handle release button firmly while bending the handle forward. The folding pivot will click into the bent position. (Fig. 3) To straighten the handle, simply lift the upper handle. The folding pivot will click into the straightened position. (Fig. 4)

Handle

Release

Button

Fig. 3

Fig. 4

CHARGING INSTRUCTIONS

1.Connect the charger plug to the charging jack or hole on the back of the sweeper. Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only KA12D090020023U. (Fig. 5)

2.This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must be charged for a

minimum 20 hours.

IMPORTANT: After initial charging, your new cordless sweeper should not be left connected to the charging adapter for a period in excess of 24 hours. A normal charge cycle is approximately 20 hours.

The manufacturer recommends that when charging the cordless sweeper, the unit be allowed to charge for approximately 20 hours and then be disconnected from the charging adapter. The charging adapter should be unplugged from the wall receptacle and stored in a convenient place until next use.

3.When recharging the unit, the on/off switch must be in the “off" position.

4.The charging light indicator on the top of the sweeper will illuminate to indicate that the sweeper is properly charging.

5.To recharge, repeat step #1 above. Charging times will vary depending upon the amount of usage between charging cycles.

NOTE: If you connect the charging adapter to the sweeper to recharge and the charging indicator light does NOT illuminate, then press the on/off button once to turn the sweeper “Off”. The charging indicator light should now light up. NOTE: Peak performance may only be realized after the unit has been charged and discharged two (2) or three (3) times.

IMPORTANT: To maintain peak performance of your cordless sweeper, it is recommended that the unit be fully discharged, then completely re-charged at least once a month.

CAUTION: Use only the charging adaptor supplied with the sweeper Do not clean the sweeper while unit is charging.

4