HOW TO USE (continued)
Remote ON/OFF Selector for bare floor or carpet ON – push down on front
*Off – push down on back for bare floors.
| ON | OFF |
|
| |
Vacuum Control |
|
|
|
|
Cleaning suction is reduced by pushing lever to LOW position. Place lever at HIGH position to increase suction for carpet cleaning.
*Power ON/OFF for canister can only be controlled by canister ON/OFF switch.
Cleaning Tools
Crevice Tool (stored inside cleaner): For crevices, corners, baseboards, between cushions.
Dusting Brush (stored inside cleaner): For furniture, blinds, books, lamp shades, shelves.
Upholstery Nozzle (stored inside cleaner):
For curtains, draperies, cushions, fabrics.
Turbo Brush: (on some models) For upholstery and for stairs.
Bare Floor Brush: (on some models) For any type of hard surface floor.
HOW TO MAINTAIN
The paper bag and filters play a very important role in the efficiency of the vacuum cleaner. The purpose of the paper bag is to trap dirt and at the same time the paper must be porous enough to allow air to pass through. If the paper bag or filters become clogged, no air can pass through the cleaner and no cleaning takes place regardless of how powerful the unit. To keep the cleaner operating at maximum efficiency, change the dust bag frequently and clean the filters as necessary.
Some fine particles can restrict airflow very quickly and will decrease performance even before the bag appears to be full. When vacuuming carpet fresheners or cleaners, plaster dust, or similar fine substances, clean the bag and filters more often.
Bag Change Indicator
The bag change indicator bar fills as the airflow through the bag decreases. Certain types of fine particles like powder, plaster dust, or carpet fibers can restrict airflow very quickly and will decrease performance even before the bag appears to be full. When the warning appears, change the disposable dust bag to restore maximum performance. If a clean dust bag does not restore maximum performance, clean the filters and check the hose and wands for obstructions.
Empty Bag | Filled Bag |
HOW TO CHANGE DISPOSABLE DUST BAG - Style CN2 and FILTER - Style EF3
NOTE: Turn off the power switch and disconnect electrical cord from wall socket before changing dust bag. Never use the cleaner without a dust bag or filters.
To remove used dust bag and check filters:
1.Unplug the hose from the bag compartment lid.
2.Squeeze bag compartment latch and swing lid up.
3.Lift exhaust filter out of bag compartment. If dirty, clean or replace. The filter can be cleaned by brushing over a waste receptacle. Place filter back in bag compartment.
4.Grasp bag collar and lift used bag out of cleaner and throw away.
5.Pull down on motor filter grille to release the motor filter. If dirty, clean or replace. The filter can be cleaned by brushing over a waste receptacle. Replace filter in grille, rotate grille up and push against cleaner to latch.
3. | 4. | 5. |
To install disposable dust bag:
1.Hold dust bag by collar and push dust bag into bag frame.
2.Rotate bag compartment lid down and press against cleaner until it latches.
Brush Roll
The brush roll turns to sweep and comb the carpet nap. Keep the brush roll free from hair and threads so it will continue cleaning. When the bristles of the brush roll no longer touch a piece of cardboard held across the bottom plate, the brush roll is ineffective because the bristles no longer touch the carpet nap. To maintain the most effective cleaning, install a new brush roll.
4
